NAS Setup: Hdds PSU external power option - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98) +--- Forum: RockPro64 Hardware and Accessories (https://forum.pine64.org/forumdisplay.php?fid=102) +--- Thread: NAS Setup: Hdds PSU external power option (/showthread.php?tid=16075) |
NAS Setup: Hdds PSU external power option - Robotik - 02-13-2022 Good day Everyone. I decided to intall a 6 SATA Drive card and pack 6 2.5'' hdds in the NAS case the problem is that the Sata power dapter can only supply enought power for 2 drives. I am looking for recomendations to supply power to the four remaining drives. Until know I have been uing a USB to Sata converted connected to a fast phone charger. It works but from time to time a drive disappears, no doubt I am exceding the USB current settings. Hence I am looking for something that can supply more current to get my Hdds up and running. I did used a 12V/5V 2A USB to IDE/SATA Power Supply Adapter For Hard Drive HDD CD-ROM Tool; of course if end up exploting after a few minute. RockPro survided I attached a few pictures of the rack for refence. Plush blanket great for antistatic I know (Not!) YOLO SATA PCIE hardware used : BEYIMEI PCIE 4x SATA card 6 ports, 6 Gbit / s SATA 3.0, boot as System Diskette, Support 6 SATA 3.0 Devices, with 6 SATA cables and a 15pin SATA to 4SATA Power Distribution Cable(ASM1166) Any suggestions? RE: NAS Setup: Hdds PSU external power option - zer0sig - 07-18-2022 that's pretty cool! if you were running SSDs, you might have enough power to split into multiple connectors in parallel, but 6 spinning disks? 2.5" draw less power but not that much less. Hmm.. |