PINE64
error screen - Printable Version

+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinecil (https://forum.pine64.org/forumdisplay.php?fid=162)
+--- Forum: General Discussion on Pinecil (https://forum.pine64.org/forumdisplay.php?fid=163)
+--- Thread: error screen (/showthread.php?tid=15289)



error screen - mikerg4 - 11-08-2021

I have just received my pinecil but I can't get it to work - I get an X !! on the screen (not sure if the photo is viewable here) - I am using an OMARS power pack with 45W PD capability.
thanks,
[Image: zyCVNAr7LxBNawnZA]


RE: error screen - mikerg4 - 11-08-2021

This should show the picture

https://photos.app.goo.gl/zyCVNAr7LxBNawnZA


RE: error screen - tllim - 11-08-2021

(11-08-2021, 09:38 AM)mikerg4 Wrote: I have just received my pinecil but I can't get it to work - I get an X !! on the screen (not sure if the photo is viewable here) - I am using an OMARS power pack with 45W PD capability.
thanks,
[Image: zyCVNAr7LxBNawnZA]

The X!! means the tip doesn't plug in to Pinecil body properly. Note: I not able to review your photo.


RE: error screen - mikerg4 - 11-09-2021

(11-08-2021, 09:40 PM)tllim Wrote:
(11-08-2021, 09:38 AM)mikerg4 Wrote: I have just received my pinecil but I can't get it to work - I get an X !! on the screen (not sure if the photo is viewable here) - I am using an OMARS power pack with 45W PD capability.
thanks,
[Image: zyCVNAr7LxBNawnZA]

The X!! means the tip doesn't plug in to Pinecil body properly. Note: I not able to review your photo.

Yes, that was it, thank you. I pushed the tip in quite hard but didn't realise I needed to loosen the screws first, doh...
mike.