+- PINE64 (https://forum.pine64.org)
+-- Forum: PinePhone (https://forum.pine64.org/forumdisplay.php?fid=120)
+--- Forum: PinePhone Hardware (https://forum.pine64.org/forumdisplay.php?fid=122)
+--- Thread: Mainboard replacement does not boot/charge (/showthread.php?tid=13764)
Mainboard replacement does not boot/charge - boarf - 05-01-2021
Hello everyone,
I got this week the Pinephone mainboard replacement (this item) and tried to set it up this afternoon. But once installed, following the instructions in the video, nothing happens at all : it doesn't boot when I push the power button, and the status led doesn't go red when I plug the charger.
I thought I made a mistake during the installation, or that I broke something, so I put the ubports mainboard back in place to test the components: the phone booted and everything seemed fine.
I set the replacement mainboard up again: same issues, the phone doesn't boot or charge.
Any ideas?
Thanks!
RE: Mainboard replacement does not boot/charge - RTP - 05-01-2021
(05-01-2021, 02:14 PM)boarf Wrote: Hello everyone,
I got this week the Pinephone mainboard replacement (this item) and tried to set it up this afternoon. But once installed, following the instructions in the video, nothing happens at all : it doesn't boot when I push the power button, and the status led doesn't go red when I plug the charger.
I thought I made a mistake during the installation, or that I broke something, so I put the ubports mainboard back in place to test the components: the phone booted and everything seemed fine.
I set the replacement mainboard up again: same issues, the phone doesn't boot or charge.
Any ideas?
Thanks!
Your link gave me a 404 not found. Not sure on the video you followed but did you try flashing an OS (it doesn't come with an OS)? I bought my 3gb upgrade board the other week, reflashed fresh OS to emmc and have had no issues.
RE: Mainboard replacement does not boot/charge - boarf - 05-02-2021
The link was to the pine64 offer for a mainboard replacement for braveheart/ubports owners, but it's just the standard 3GB/32GB mainboard.
And yes, you're right, I just followed the steps in the item page in the pine store, but they actually were incomplete: I should have read the wiki first! So basically:
- mainboard come without preloaded system, even the factory testing image (I thought it had the factory image)
- the usb firmware must be updated.
