+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=111)
+--- Forum: General Discussion on Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=112)
+--- Thread: FlexProp IDE (/showthread.php?tid=13205)
FlexProp IDE - botulism - 02-22-2021
I use the Parallax Propeller family of microcontrollers. The normal IDE is on Windows, but FlexProp can be compiled to run on Linux. It would be spamtacular if I had an IDE on a Pinebook Pro! I lack the time and knowledge to make this happen. I also always run into some permission issue with any programmable device that always kicks my butt.
Is this doable? If so, can someone please educate me on how to pull this off?
Thank you!
https://forums.parallax.com/discussion/170730/flexprop-a-complete-programming-system-for-p2-and-p1/p1