Hall Sensor - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: Pinecil (https://forum.pine64.org/forumdisplay.php?fid=162) +--- Forum: Pinecil Hardware and Accessories (https://forum.pine64.org/forumdisplay.php?fid=165) +--- Thread: Hall Sensor (/showthread.php?tid=12872) |
Hall Sensor - schuschu - 01-23-2021 Hi, Since the schematic kindly tells me that the hall sensor is not populated I was wondering if it was sufficient to just solder one on the board (since the firmware apparently anyway checks via i2c if its presenet) or are the caps also omitted? Best, schuschu RE: Hall Sensor - Ralim - 01-28-2021 (01-23-2021, 08:59 AM)schuschu Wrote: Hi,You _should_ be fine to just attach the sensor. Not 100% if the caps are emitted but it will probably work without them anyway RE: Hall Sensor - schuschu - 01-29-2021 (01-28-2021, 04:17 AM)Ralim Wrote:(01-23-2021, 08:59 AM)schuschu Wrote: Hi,You _should_ be fine to just attach the sensor. All caps present and accounted for, says Zzzz when i put a magnet next to it now RE: Hall Sensor - ssl-3 - 06-05-2021 I'd like to add a Hall effect sensor. Which one did you use? RE: Hall Sensor - gadjet - 02-02-2022 (06-05-2021, 02:37 PM)ssl-3 Wrote: I'd like to add a Hall effect sensor. Which one did you use? https://www.mouser.co.uk/ProductDetail/Silicon-Labs/SI7210-B-00-IV?qs=gt1LBUVyoHm9MLEqID%252B8eQ%3D%3D&gclid=Cj0KCQiA9OiPBhCOARIsAI0y71DSKIQJ-1PTT89Z-GNRIvWV0Vzpx8cKFQclLHctGA_o21VGOS0sSH4aAiN3EALw_wcB I think it's this one |