PINE64
Manjaro system update failed, bricked PinePhone - Printable Version

+- PINE64 (https://forum.pine64.org)
+-- Forum: PinePhone (https://forum.pine64.org/forumdisplay.php?fid=120)
+--- Forum: General Discussion on PinePhone (https://forum.pine64.org/forumdisplay.php?fid=127)
+--- Thread: Manjaro system update failed, bricked PinePhone (/showthread.php?tid=12314)

Manjaro system update failed, bricked PinePhone - jalanga - 11-26-2020

Hi,

I received my PinePhone today with manjaro preinstalled.
I wanted to update the os, the system update was stuck for ~1hour in searching update.
So i opened the terminal and run
Code:
sudo pacman -Syuu

The update got stuck at an error about perl and default local. I couldn't do nothing, the phone did not respond so after 1 hour I removed the battery.

Now, when I start it the red led lights is showing up, but on the screen... nothing.
I bought an SDXC ScanDisk extreme 64GB, put ubuntu touch on it..and nothing. No red led light, nothing on screen.
I used the Pine64 installer to create the bootable SD card.
The image I downloaded from here: https://ci.ubports.com/job/rootfs/job/rootfs-pinephone/ .

What should I try to make it work? 

Thank you.

RE: Manjaro system update failed, bricked PinePhone - Veraendert - 11-27-2020

(11-26-2020, 06:32 AM)jalanga Wrote: Hi,

I received my PinePhone today with manjaro preinstalled.
I wanted to update the os, the system update was stuck for ~1hour in searching update.
So i opened the terminal and run
Code:
sudo pacman -Syuu

The update got stuck at an error about perl and default local. I couldn't do nothing, the phone did not respond so after 1 hour I removed the battery.

Now, when I start it the red led lights is showing up, but on the screen... nothing.
I bought an SDXC ScanDisk extreme 64GB, put ubuntu touch on it..and nothing. No red led light, nothing on screen.
I used the Pine64 installer to create the bootable SD card.
The image I downloaded from here: https://ci.ubports.com/job/rootfs/job/rootfs-pinephone/ .

What should I try to make it work? 

Thank you.

You can't brick the PinePhone. Fully charge the phone and just use the instructions from the Wiki to write to SD: https://wiki.pine64.org/wiki/PinePhone_Installation_Instructions using the current Ubports repo over at https://ci.ubports.com/job/rootfs/job/rootfs-pinephone-systemimage/ as the repo you have been using is outdated (it says so at the top of the page).