+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98)
+--- Forum: General Discussion on ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=99)
+--- Thread: Automatically run after power recovery (/showthread.php?tid=7430)
Pages:
1
2
RE: Automatically run after power recovery - elik745i - 09-21-2019
Dears, can you tell me which GPIOs are used to control volume up volume down as when power gets back ROCK64 boots into recovery and I can not navigate through it.
RE: Automatically run after power recovery - lcyepiz - 10-03-2019
[quote pid='46594' dateline='1558909836']
where can find the numbers of components to try this modification, the Rock64pro dont have component number in the board,
do you have a board outline with number components?
Can you help me?
[/quote]
RE: Automatically run after power recovery - dkaparis - 09-26-2020
(07-27-2019, 08:51 PM)TheWiley Wrote: I played a bit with this today and found that the auto-power-on seems to work less than 1/3rd of the time for me. When it does work, I do see the ethernet NIC lights come on immediately and the board starts responding to ping 30-60 seconds later. When it doesn't work, I get no NIC lights. I think that means I have a hardware problem?
If it makes a difference, I'm running with the 12v/5A PSU.
It also seems to matter how long the power is off - I haven't checked systematically, but auto-start seems to be more reliable if the board is unplugged for more than a minute or so. Does that make sense?
Did you manage to find a solution? I have the same issue, only my board never auto boots after re-powering, not matter for how much time I unplug it. The green LED next to the power jack lights up, but the ethernet NIC lights don't. The only way to start it is by pushing the power button. I'm also using the 12V 5A PSU from the Pine store.
RE: Automatically run after power recovery - dryohansen - 10-24-2020
I have this problem with rockpro64 and PSU 12v5a from pinestore. Do you have any solutions ?
RE: Automatically run after power recovery - rolisr - 11-30-2020
I can confirm the same bad behaviour: after power loss or even if the power is disconnected manually, the rockpro64 does not boot anymore until the power button is pressed or the board gets cool in a few hours
