(02-24-2019, 03:35 AM)ddimension Wrote:

(12-18-2018, 04:24 PM)ddimension Wrote:

(12-17-2018, 06:44 AM)H.HSEL Wrote: I bought a RockPro64 and am trying to build a budget 10GbE storage.
After changing its MTU from 1500 (default) to 9000, I performed iperf and I got a result around 2.70Gbps, though it seems that the result is not stable, sometimes the value going down to 2.30Gbps or lower.
I don't know why but manually assining iperf processes to a specific core (taskset -c 5 iperf -s, for example) seems to offer better and stable results that is 3.00Gbps.

Hi!

I also tested aquantia cards and came to the result, that the driver has poor performance, i.e. missing offloading capabilities. I also have an tehuti tn4xxx network card. This one gave me about 9GBit/s single threaded iperf3 performance, a lot better. Even vlan offloading works.

If you want to give it a try, you have define RX_REUSE_PAGES in tn40.h

After long testing I experienced OOM on higher loads. The problem is the ARM memory management and DMA capabilities.
You should set no coherent_pool in kernel args and provide a big area for contingous memory (which will be used by DMA) like:
cma=512M

Perhaps a smaller area possible.

BTW, I use 4 lanes:

Code:

01:00.0 Ethernet controller: Tehuti Networks Ltd. TN9510 10GBase-T/NBASE-T Ethernet Adapter
    Subsystem: Tehuti Networks Ltd. Ethernet Adapter
    Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
    Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
    Latency: 0
    Interrupt: pin A routed to IRQ 233
    Region 0: Memory at fa000000 (64-bit, prefetchable) [size=64K]
    Capabilities: [50] MSI: Enable+ Count=1/1 Maskable- 64bit+
        Address: 00000000fee30040  Data: 0000
    Capabilities: [78] Power Management version 3
        Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
        Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
    Capabilities: [80] Express (v2) Endpoint, MSI 00
        DevCap:    MaxPayload 512 bytes, PhantFunc 0, Latency L0s <64ns, L1 <2us
            ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset- SlotPowerLimit 0.000W
        DevCtl:    Report errors: Correctable- Non-Fatal- Fatal- Unsupported-
            RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+
            MaxPayload 256 bytes, MaxReadReq 512 bytes
        DevSta:    CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr+ TransPend-
        LnkCap:    Port #1, Speed 5GT/s, Width x4, ASPM L0s L1, Exit Latency L0s <512ns, L1 <2us
            ClockPM- Surprise- LLActRep- BwNot- ASPMOptComp-
        LnkCtl:    ASPM Disabled; RCB 64 bytes Disabled- CommClk+
            ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
        LnkSta:    Speed 5GT/s, Width x4, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
        DevCap2: Completion Timeout: Range A, TimeoutDis+, LTR-, OBFF Not Supported
        DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR-, OBFF Disabled
        LnkCtl2: Target Link Speed: 5GT/s, EnterCompliance- SpeedDis-
             Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS-
             Compliance De-emphasis: -6dB
        LnkSta2: Current De-emphasis Level: -6dB, EqualizationComplete-, EqualizationPhase1-
             EqualizationPhase2-, EqualizationPhase3-, LinkEqualizationRequest-
    Capabilities: [100 v1] Virtual Channel
        Caps:    LPEVC=0 RefClk=100ns PATEntryBits=1
        Arb:    Fixed- WRR32- WRR64- WRR128-
        Ctrl:    ArbSelect=Fixed
        Status:    InProgress-
        VC0:    Caps:    PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
            Arb:    Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
            Ctrl:    Enable+ ID=0 ArbSelect=Fixed TC/VC=ff
            Status:    NegoPending- InProgress-
    Kernel driver in use: tn40xx
    Kernel modules: tn40xx

(08-14-2019, 12:09 AM)igorp Wrote: 10GB network testings on Rock64PRO with Aquantia based card. Porting latest upstream driver to 4.4.y was not very successful (too much troubles) ... only with 5.3.y, default MTU ->



On the other side also Aquantia connected via Thunderbolt/USB-c gen2 to stock Debian Buster (Dell XPS13)

https://twitter.com/armbian/status/1161515847124488198