PINE64
New pinetab2 - can't charge it - Printable Version

+- PINE64 (https://forum.pine64.org)
+-- Forum: PineTab (https://forum.pine64.org/forumdisplay.php?fid=140)
+--- Forum: General Discussion on PineTab (https://forum.pine64.org/forumdisplay.php?fid=141)
+--- Thread: New pinetab2 - can't charge it (/showthread.php?tid=19678)

Pages: 1 2


RE: New pinetab2 - can't charge it - tmhorne - 05-13-2025

(02-20-2025, 12:33 AM)biketool Wrote:
(02-19-2025, 08:33 AM)tmhorne Wrote:
(02-19-2025, 06:57 AM)biketool Wrote:
(02-18-2025, 07:30 AM)tmhorne Wrote:
(02-17-2025, 12:36 PM)biketool Wrote: I am sure you have tried this, but do you have another USB-C cable to try?
(edit) and if you plug it into a Linux machine does it show up on lsusb?
(edit2) Since the keyboard/case interfaces via a USB docking port can you try removing the case?

Yes, I have tried a different cable and also a different adapter. Same result.

Plugging the tablet into another linux machine to see if it shows up on lsusb? No, I have not. I can try that when I get home from work this afternoon.

Another data point: I played with it last night until the battery died. Then I plugged it in and went to bed and it charged up to 20% overnight. If I look at the battery graph, though, it doesn't look like it charged. Maybe it was just hot when it said 0% and shut down? The graph says it went down to 20 and stayed there. There's definitely something wrong. 

Keyboard/case: 
I plugged it in with a new adapter and cord that I know work elsewhere. Nothing.
I just removed it from the keyboard/case and plugged it in and it started charging and it even made a "brrring" sound.
I removed the cable, put it back in the case, then re-plugged it in and it started charging. While in the case, it did not make the sound.

So I'm at a total loss. There's definitely a short somewhere and I don't think it's the cable.

the kb case works though? lights up, types, and moves cursor?
I wonder if the other 20% overnight charge is a backup flat battery slow charge mode, have to look at the charge controller data sheet.

Yeah, the keyboard and mouse work when I have it positioned correctly.
I have to make sure it's pushed back all the way and it works.

After I followed your advice and removed it from the keyboard case yesterday, it charged fully in just under 4 hours.

I'll run it down a bit and try to charge it again tonight.

I wonder if the KB forces aUSB 2.1 mode which turns out to be a slow charge I have not really naticed a difference on my pinetab2.


I can't charge it again.

I think the battery drained fully and since it doesn't charge while it's not powered on, I'm stuck.
It can't power on because the battery is dead.
I can't charge the battery because I can't power it on.

Maybe I can disassemble the device, then manually charge the battery a little somehow?

It's not 3 months old and it's a brick.