(01-13-2020, 06:59 PM)Sally Wrote: i attempted to update my  4 hour old Pinebook Pro. Now I can't sign into Pinebook Pro using rock, rock. The letters typed not correct.


What can I do? Do I have to reinstall the OS or is my new Pinebook Pro bricked. Thank you for any assistance.

(01-13-2020, 07:47 PM)Sally Wrote:

(01-13-2020, 06:59 PM)Sally Wrote: i attempted to update my  4 hour old Pinebook Pro. Now I can't sign into Pinebook Pro using rock, rock. The letters typed not correct.


What can I do? Do I have to reinstall the OS or is my new Pinebook Pro bricked. Thank you for any assistance.

Kinda flustered ...

 I didn't say what I was attempting to update, the keyboard firmware. I'm not sure what happened. Can I reinstall Debian?  Thank you for any assistance you can give me. 

My regards, 

Sally

(01-13-2020, 08:31 PM)hpc@scale Wrote:

(01-13-2020, 07:47 PM)Sally Wrote:

(01-13-2020, 06:59 PM)Sally Wrote: i attempted to update my  4 hour old Pinebook Pro. Now I can't sign into Pinebook Pro using rock, rock. The letters typed not correct.


What can I do? Do I have to reinstall the OS or is my new Pinebook Pro bricked. Thank you for any assistance.

Kinda flustered ...

 I didn't say what I was attempting to update, the keyboard firmware. I'm not sure what happened. Can I reinstall Debian?  Thank you for any assistance you can give me. 

My regards, 

Sally

I ran into a similar problem when running the instructions that update the trackpad firmware for ansi.  After the Step 1 reboot, I could not connect to the laptop via ssh since the wifi hadn't reconnected.  I suspected that the laptop wifi didn't connect because I didn't login.  However, I couldn't login because the keyboard mapping was mixed up.  

I solved the problem via trial and error by determining which keys were mapped to r, o, c, k, and Enter.  This allowed me to login which started the wifi. I then logged into my router to determine the ip address of the laptop.  The name of the connection listed by the router is Debian-Desktop.  Below are the key mappings I used to login:
r = y
o = .
c = h
k = ' 
\ = Enter
Enter = backspace

Note: use \ to get to the Password field from the ID field.

Hope this helps your problem!

(01-13-2020, 08:31 PM)hpc@scale Wrote:

(01-13-2020, 07:47 PM)Sally Wrote:

(01-13-2020, 06:59 PM)Sally Wrote: i attempted to update my  4 hour old Pinebook Pro. Now I can't sign into Pinebook Pro using rock, rock. The letters typed not correct.


What can I do? Do I have to reinstall the OS or is my new Pinebook Pro bricked. Thank you for any assistance.

Kinda flustered ...

 I didn't say what I was attempting to update, the keyboard firmware. I'm not sure what happened. Can I reinstall Debian?  Thank you for any assistance you can give me. 

My regards, 

Sally

I've been keeping notes on my PBP setup/configure.  I experienced the same issue.  I wasn't patient enough to try and figure out which key produced which character.  I used an external keyboard.  My notes:

   # Apply trackpad/keyboard firmware [https://forum.pine64.org/showthread.php?tid=8407]

   $ git clone https://github.com/ayufan-rock64/pinebook-pro-keyboard-updater
   $ cd pinebook-pro-keyboard-updater
   $ sudo apt-get install build-essential libusb-1.0-0-dev xxd
   $ make

   $ sudo ./updater step-1 ansi
   $ sudo reboot (my keyboard became unusable by step-1 so reboot via menu)
   
   # Attach usb keyboard to finish
   $ cd /pinebook-pro-keyboard-updater
   $ sudo ./updater step-2 ansi
   $ sudo reboot

(01-13-2020, 09:07 PM)ColoBill Wrote:

(01-13-2020, 08:31 PM)hpc@scale Wrote:

(01-13-2020, 07:47 PM)Sally Wrote:

(01-13-2020, 06:59 PM)Sally Wrote: i attempted to update my  4 hour old Pinebook Pro. Now I can't sign into Pinebook Pro using rock, rock. The letters typed not correct.


What can I do? Do I have to reinstall the OS or is my new Pinebook Pro bricked. Thank you for any assistance.

Kinda flustered ...

 I didn't say what I was attempting to update, the keyboard firmware. I'm not sure what happened. Can I reinstall Debian?  Thank you for any assistance you can give me. 

My regards, 

Sally

I've been keeping notes on my PBP setup/configure.  I experienced the same issue.  I wasn't patient enough to try and figure out which key produced which character.  I used an external keyboard.  My notes:

   # Apply trackpad/keyboard firmware [https://forum.pine64.org/showthread.php?tid=8407]

   $ git clone https://github.com/ayufan-rock64/pinebook-pro-keyboard-updater
   $ cd pinebook-pro-keyboard-updater
   $ sudo apt-get install build-essential libusb-1.0-0-dev xxd
   $ make

   $ sudo ./updater step-1 and
   $ sudo reboot (my keyboard became unusable by step-1 so reboot via menu)
   
   # Attach usb keyboard to finish
   $ cd /pinebook-pro-keyboard-updater
   $ sudo ./updater step-2 ans
   $ sudo reboot

(01-13-2020, 10:26 PM)Lyn Wrote: I'm in a similar predicament with my new PBP. Using an external keyboard, step-1 ansi seemed to work. Rebooted and executed: $ sudo ./updater step-2 ansi.
Log ends with:
Verify mismatch: type=f2, pass=e2, received=d2
Touchpad verify (type=242, pass=226) data failed
Touchpad erase failed