PINE64

Full Version: Android TV 9 - sleeping mode and backup
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hi everyone,

As a real noobie I have install android tv on my rock64 card board; I'm using it principaly to run KODI (might not be the smartest way to do it but that was my way).
It works almost perfectly but I am facing some problems:
- the board turns off when turning the TV in sleeping mode: is there a way to deactivate on android tv specifically the ANYNET+? what is weird is that the board turn off and on with the official IR remote that work, but I can't awake the board once off by the tv remote.
Any solutions?
- android tv is running very well but it isn't constant. Sometimes it is slow (more than 3 minutes) to fast to start and in that case it is running then slow ; I'm suspecting my RJ45 plug/connection (it connected to the network through a cable)
did someone have had any problem with the onboard plug? 
- Backup(ing) my PC computer: what would be the simpliest way (using android tv) to back my PC on hard disk plugged to the ROCK64?
- last but not least: chromecast is integrated to android tv, is there a way to cast from my phone to the ROCK64 if the connection is done via a RJ45 wire?

I have checked on the different thread and I haven't found the answer, but I might haven't look well

thank for reading this message,

Ludovic