PINE64

PINE64 > PINE A64(+) > Pine A64 Hardware, Accessories and POT > POT modules > Z-Wave - Full and Low Power Inclusion mode
Full Version: Z-Wave - Full and Low Power Inclusion mode
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

B34N

03-25-2017, 02:24 PM
I have a Pine64 with the Pine US Z-wave module running openHAB2. I'm finally starting to move my z-wave network over from my old and dying Aeon Z-Stick. Some of my z-wave devices do not seem to support Network Inclusion mode and need a controller to be in directly reachable. Am I out of luck if I cannot bring my Pine64 in range of these devices? Or is there a method to have a secondary controller that I can bring close to these devices for pairing?

If I'm better off just buying a new removable z-wave controller stick and scrapping my Pine64 then please let me know.

Thank you,
B34N

B34N

03-26-2017, 06:03 PM
(03-25-2017, 02:24 PM)B34N Wrote: [ -> ]If I'm better off just buying a new removable z-wave controller stick and scrapping my Pine64 then please let me know.

I am under the impression that Gen 5 Z-Wave devices can be backed up and restored to a new device. If so, would that mean that I could backup the Pine64 controller and move to a Aeon controller if I find the need in the future?
PINE64 > PINE A64(+) > Pine A64 Hardware, Accessories and POT > POT modules > Z-Wave - Full and Low Power Inclusion mode