07-09-2023, 03:28 AM
Hello,
I followed this guide: https://archlinuxarm.org/platforms/armv8...ner/pine64 to install arch on an sd card and then successfully booted to rock64, but I did the mistake and run "rm /boot/boot.scr" and now I'm unable to boot again.
After than I tried following again the same steps (from step 5-10) a couple of times but I always get the same result (when I boot all the leds are working and the the monitor does not display anything)
Any ideas on what is going on and how I can debug this?
I followed this guide: https://archlinuxarm.org/platforms/armv8...ner/pine64 to install arch on an sd card and then successfully booted to rock64, but I did the mistake and run "rm /boot/boot.scr" and now I'm unable to boot again.
After than I tried following again the same steps (from step 5-10) a couple of times but I always get the same result (when I boot all the leds are working and the the monitor does not display anything)
Any ideas on what is going on and how I can debug this?