Waterproof Enclosure Knockout Size - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98) +--- Forum: General Discussion on ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=99) +--- Thread: Waterproof Enclosure Knockout Size (/showthread.php?tid=12493) |
Waterproof Enclosure Knockout Size - faultywarrior - 12-13-2020 Does anyone know what the correct size and thread pattern the threaded knockouts on the Aluminum Waterproof Enclosure are? I can't seem to figure it out, despite having 3D printed several different sizes and styles of bolts; none of which seem to match up. I figure before I waste more resin and time printing more and more test parts, I'd just ask. I can't find any real spec sheets or drawings that would list this data, and my own measurements are inconclusive. RE: Waterproof Enclosure Knockout Size - faultywarrior - 12-13-2020 (12-13-2020, 12:07 PM)faultywarrior Wrote: Does anyone know what the correct size and thread pattern the threaded knockouts on the Aluminum Waterproof Enclosure are? I can't seem to figure it out, despite having 3D printed several different sizes and styles of bolts; none of which seem to match up. I figure before I waste more resin and time printing more and more test parts, I'd just ask. I can't find any real spec sheets or drawings that would list this data, and my own measurements are inconclusive.Update: I've found a drawing of the enclosure after doing a bunch of digging. It's inexplicably buried at the end of the Pine A64's wiki page. Anyways - to save others the hassle, the bigger 3 bolts are 5/8-24 with the smaller one being M12x1. The drawing is linked below: https://files.pine64.org/doc/datasheet/case/pine64%20Die%20Cast%20casing-final.jpg |