06-04-2020, 11:36 AM
(06-03-2020, 02:55 AM)danielt Wrote:(06-01-2020, 08:43 PM)VMMainFrame Wrote:(06-01-2020, 03:48 AM)danielt Wrote: Strange... so in summary everything appears to work perfectly! Thus it is *very* strange the watch doesn't show the UI automatically at boot.
I guess as a final check you should use cat('/flash/main.py') to make sure that the contents of main.py are correct. Perhaps you could also confirm that you are not acidentally booting into safe mode are you (if you have the button pressed when the pine cone disappears to the final time then the watch will enter safe mode and skip the startup file).
I issued the cat command and an ls command and the results are confusing, considering the information I previously provided.
Yes, confusing indeed.
I think to get to the bottom of this I think I'll need to change to the code to boot.py to get some more information out. IIRC you were using the 0.2 release... are you compiling yourself or working just with the binary release? Just wondered if I should share patches or .zip file?
PS Since we're getting to the point of throwing code around this might also be a good point to migrate the discussion to the github issue tracker for wasp-os? Attachments work out better there...
Daniel,
Yes, I was using the 0.2 file from your web page. I have not compiled anything, I am using your binaries.
I can move this discussion to the github tracker. Do you want me to open a new issue or add on to one that already exists?
Hugh