01-04-2020, 04:04 AM
(This post was last modified: 01-04-2020, 06:16 AM by sigmaris.
Edit Reason: added link to build artefacts
)
(01-03-2020, 07:52 PM)belfastraven Wrote: ...
=> run bootcmd_nvme0
Device 0: Vendor: 0x144d Rev: EXD7101Q Prod: S444NE0K603440
Type: Hard Disk
Capacity: 244198.3 MB = 238.4 GB (500118192 x 512)
... is now current device
** Unrecognized filesystem type **
JI'm just including the log this time so that you can see that I did use the proper images....
Once again, thanks.
@belfastraven thanks for testing, and pasting the full log here. Looks like your NVMe device is detected OK, I suspect the "Unrecognized filesystem type" problem is just because there is no BTRFS support in this build (it's not enabled in U-Boot by default).
I enabled BTRFS in the config and re-built U-Boot, I haven't tested this yet but you could try using the resulting build, attached:
mmc_u-boot.zip (Size: 471.35 KB / Downloads: 447)
Edit: if you need the SPI binaries from this build, they can be downloaded from this build artifacts page.
