02-12-2020, 09:53 AM
(This post was last modified: 02-12-2020, 09:57 AM by moonwalkers.)
(02-12-2020, 03:58 AM)dumetrulo Wrote: I have started playing around with this installer, and set up a minimal Bullseye (no tasks) on an SD card.
How do I go about configuring WiFi on this minimal setup so I can start adding components?
Also I noticed that the minimal setup is missing basic things like a shutdown or poweroff command, how can I add these at the time of installation?
Even if you don't select any tasks you should end up with wpasupplicant and network-manager packages already installed. In my installation all I needed to do was run
Code:
nmcli device wifi connect <SSID> password <password>