(03-15-2019, 11:18 PM)AZClusterboard Wrote:(03-15-2019, 05:29 PM)BryanS Wrote: They aren't asking for addresses from the router, so I wonder if there's something wrong with my clusterboard.
They won't pull down DHCP at all?
They weren't, but they are now. I assumed the most obvious answer here, that of I did something wrong. I went back and re-read your guide carefully, and stopped where you said you HAD to use Xenial. I loaded that on to a test card, and it appeared in the router as a device within a minute.
So, I guess I need to pay attention to the manual. The board currently has 3 modules on it, just doing some generic network tasks for a burn-in. The only thing I have left to do is make sure there's no unnecessary desktops loading with this particular version. I assume there isn't.
Thank you for the replies, sometimes it just takes someone asking you about it to make you go back and look at your process differently.