Individual SOPINE Power On After Shutdown?
#1
On the clusterboard v2.2 the reset button won't restart shutdown SOPINE modules - they stay off with a dim PL7 green light. Any suggestions to restart individual SOPINEs? 

I'm leaning toward shorting the VCC and GND on the jumper pins beside each SOPINE. I could rig each set of jumpers with a toggle switch. Any suggestions on the best way to do this without harming my SOPINEs?
  Reply
#2
Maybe I'm not understanding you right, but typically shorting VCC directly to GND in any environment is a bad idea.

I would also like to know if there is a way to power on individual SOPINEs after they've been shutdown. As you mention, shorting pin 4 (RESET) to ground does not trigger a power-on, although it does force-reboot a running SOPINE. I've tried pin 5, which is labeled PWR_ON, but neither shorting it to ground nor VCC seem to have any effect. Unless I'm just doing it wrong...
  Reply
#3
PWR_ON to GND works for me, but it needs to be held low for a few seconds.
  Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Network problems (actually bad power supply) Unkn0wn 12 423 10-17-2019, 09:17 AM
Last Post: venix1
  SOPine modules stay off at reboot? PeterKeuning 10 1,067 09-20-2019, 05:05 AM
Last Post: Dreamwalker
  Power Switch AZClusterboard 1 186 02-16-2019, 06:55 AM
Last Post: mdmbc
  How much force does it take to insert a SOPINE module? jbobspants 0 96 01-17-2019, 12:15 PM
Last Post: jbobspants
  Compiling on the Sopine Cluster khaosgrille 3 488 08-10-2018, 06:17 AM
Last Post: khaosgrille
  Kubernetes on SoPine cluster part.1 maya.b 3 2,668 04-18-2018, 08:31 AM
Last Post: PigLover
  Question on the power resistors bergera 2 394 02-15-2018, 08:20 AM
Last Post: bergera
  sopine cluster thermal images maya.b 4 777 12-29-2017, 02:51 PM
Last Post: Luke

Forum Jump:


Users browsing this thread: 1 Guest(s)