06-30-2019, 08:12 PM
(This post was last modified: 06-30-2019, 08:47 PM by TheSupercomputer.)
Repeating every step seems to fix it, the fan is now spinning for some seconds goes of for a few seconds and start spinning again.
The Rockpr64 temps readed from Pihole are always above 50 degrees so there should be an pwm signal al the time, or is the on of cycle the pwm control?
EDIT: With "always on" option I got the behavior i was expected, exept for that if the minimum temp is reached ats produces an load spike pushing the temp above the minimum so the fan will speed up, slow down until near stop and spin up again.
The Rockpr64 temps readed from Pihole are always above 50 degrees so there should be an pwm signal al the time, or is the on of cycle the pwm control?
EDIT: With "always on" option I got the behavior i was expected, exept for that if the minimum temp is reached ats produces an load spike pushing the temp above the minimum so the fan will speed up, slow down until near stop and spin up again.