Tool to Control Fan - fanctl

[tuxd3v]

Thank you. Now it shows a status.

Code:

root@rockpro64Nas:~# service ats status
● ats.service - ATS - Active Thermal Service
  Loaded: loaded (/lib/systemd/system/ats.service; enabled; vendor preset: enabled)
  Active: active (running) since Thu 2018-11-15 16:18:13 UTC; 23s ago
Main PID: 924 (lua)
   Tasks: 1 (limit: 4915)
  CGroup: /system.slice/ats.service
          └─924 lua /usr/local/sbin/ats

Nov 15 16:18:13 rockpro64Nas systemd[1]: Started ATS - Active Thermal Service.

Now what do i have to do exactly to get the fan started

You need to plug the fan 2 pin conector in the board, red wire is(+), black is(-). 
It should start automatically, when temps above 40C

I´ve attached the fan to Port Nr. 4 (http://wiki.pine64.org/index.php/ROCKPro64_Main_Page)
but it´s still not spinning.
What has to be above 40c?
The CPU or the HDD´s? because the HDD´s are at 44c right now.
And i cannot see the CPU temp right now. dont know why.

dont i have to install your programm again? because in the beginning i had errors while installing...

Do this,
You can install again, the process is automatic.
It will remove the other version and install a new one..you can repeat the amount of times you want..

But ats starts the Fan when CPU, or GPU is above or equal to 40C.

One way to test is, starting ats in test mode:

Code:

service ats stop
ats --test

It will print Temps, and the Power it apply to the fan.
After testing,

Then when you want the service up:

Code:

service ats start