[Jan 06] Arch Linux (20171225-1) PINE A64(+) Pinebook A64-LTS/SOPINE | [Jan 04] Linux (0.5.15-136) ROCK64 | [Jan 04] Android (20171204) ROCK64 | [Dec 22] Stretch Mate (0.5.15-136-20171222) ROCK64 | [Dec 21] openHAB 2 (v1.4) PINE A64(+) | [Dec 11] Volumio (2.315) PINE A64(+) A64-LTS/SOPINE | [Dec 11] Armbian (5.35) PINE A64(+) Pinebook A64-LTS/SOPINE | [Dec 8] OpenMediaVault (0.5.15-136) ROCK64

Getting Started | Visit the WIKI | IRC Logs | Forum Rules/Policy


Onboard IR receiver
#1
Hi!

I'm unable to find any info about how to start using the onboard IR receiver on the Rock64 on linux.

Can you point me to some info on this subject?
Reply
#2
Bump!

I don't need a detailed tutorial, but giving me a GPIO pin to which the IR receiver is connected or where do I put a dt_overlay setting, or something of this sort which gives me a direction would be welcome.
Reply
#3
The device tree node below should enable the IR receiver.

Code:
ir-receiver {
    compatible = "gpio-ir-receiver";
    gpios = <&gpio2 RK_PA2 GPIO_ACTIVE_LOW>;
    linux,rc-map-name = "rc-pine64";
    pinctrl-0 = <&ir_int>;
    pinctrl-names = "default";
    status = "okay";
};
See https://github.com/Kwiboo/linux-rockchip...#L108-L115
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)