01-10-2018, 04:56 PM
Hi,
Any idea if the Z-Wave module for both Pine64+ and LTS are the same? i.e. will the one bought for pine64+ work on LTS?
I currently have xenial-minimal from ayufan-pine64 repositories, ubuntu-mate installed.
I have also installed Openhabian from here (manual steps)
https://docs.openhab.org/installation/op...nual-setup.
+
Its all up and running.
When I install the z-wave binding and try to get the z-wave serial controller, it says port /dev/ttyS1 or S0 does not exist.
Any idea as to how to get this work?
The same z-wave module was working fine on another Pine64+ board
Thanks
Sailesh
Any idea if the Z-Wave module for both Pine64+ and LTS are the same? i.e. will the one bought for pine64+ work on LTS?
I currently have xenial-minimal from ayufan-pine64 repositories, ubuntu-mate installed.
I have also installed Openhabian from here (manual steps)
https://docs.openhab.org/installation/op...nual-setup.
+
Its all up and running.
When I install the z-wave binding and try to get the z-wave serial controller, it says port /dev/ttyS1 or S0 does not exist.
Any idea as to how to get this work?
The same z-wave module was working fine on another Pine64+ board
Thanks
Sailesh