swap SPI_CLK_M2 and SPI_CSN0_M2
#1
Hi

I finally managed to get SPI going, all the signals seem to be there but I see my clock signal (SPI_CLK_M2, pin23 on PI2 header) where the chip select (SPI_CSN0_M2, pin24 on PI2 header) should be and vice versa.

How to swap these around?

Also, is it possible to stop/start driving these pins at runtime? How?
  Reply


Messages In This Thread
swap SPI_CLK_M2 and SPI_CSN0_M2 - by dontpostalot - 12-18-2017, 10:25 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by xalius - 12-19-2017, 09:16 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by xalius - 12-19-2017, 04:14 PM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by coldfish - 12-26-2017, 12:32 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-08-2018, 08:00 PM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-09-2018, 08:14 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-10-2018, 06:40 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-10-2018, 10:40 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by GaryLa - 01-11-2018, 07:59 AM
RE: swap SPI_CLK_M2 and SPI_CSN0_M2 - by mcerveny - 08-18-2018, 02:22 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)