laser engraving the lid and other plans.
Just got my pinebook two days ago.To get my feet wet with modding I decided to start small and do a simple case mod. I have access to a laser cutter at work, so I tried engraving a light pattern on the lid. There were a few problems with alignment but I think it turned out pretty neat.
[Image: 22rczC0.jpg]

Next up I would like to design a replacement for the small companion pcb in the pinebook. The plan is to keep the original functionality while adding a small FPGA either a Spartan 3A or an ice40. This way I can have some fast reconfigurable IOs with a USB bus to the SOC. Does anyone know if the layout for a small board is available somewhere?

Messages In This Thread
laser engraving the lid and other plans. - by bits_and_wires - 10-24-2017, 02:06 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)