How to Write an Image to the eMMC Module Tutorial

[MarkHaysHarris777]

Really good guide!

But I would just like to make it clear that this guide is for Linux images!  Maybe you should mention that clearly in the OP, Mark.

If you are looking for how to install Android onto eMMC, there are much easier ways. Such as my own SADIE script. Windows version of SADIE is still in the works, hopefully for release later this week.

Noted, and corrected.  Actually, this process is much much easier than it at first glance appears;  I used this procedure today during test and loaded my new Rock64 board eMMC in less than ten minutes from start to finish -- no hits, no runs, no errors !

I also have ported ayufan's script to the rock64 -- rock64_install_to_emmc,  which further simplifies things by allowing the user to select the system and version, as well automatically generating the curl file;  very nice.

Thanks for the tip fire219.

---

I just searched the forums and cannot find the serial console tutorial that you refer to. Can you provide a link? I have a serial cable that I have used with RPis over the years and so am hoping that I can use that one.

Sent from my SM-T537V using Tapatalk

---

My apologies, I found it here: https://forum.pine64.org/showthread.php?tid=4674

Sent from my SM-T537V using Tapatalk

Thank you for the tip;  I corrected the post with the hyper-link;  the intended one you may get right here.