Homegear integration and CC1101
#1
Hi,

I want to use Pine64 as a home-assistant.io server with homegear installed to control eq-3 max! thermostats. I managed to install all of the software but problem occurred after I connected CC1101 radio board to pine. I followed this diagram ti-cc1101.png which is for Raspberry but I found all of the pins with help from this site http://pixcl.com/wp/decaf-boards-and-the...rypie-2-3/ 
Unfortunately home-gear doesn't see the board and I can't figure out where is the problem. Do I need to change something in OS config or GPIO interface is not working in current development state?

Thanks in advance for any suggestions
  Reply


Messages In This Thread
Homegear integration and CC1101 - by Festyk - 02-19-2017, 02:42 PM
RE: Homegear integration and CC1101 - by Festyk - 02-21-2017, 03:20 AM
RE: Homegear integration and CC1101 - by dkryder - 02-21-2017, 04:30 AM
RE: Homegear integration and CC1101 - by Festyk - 02-21-2017, 08:25 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)