Correct Voltage For Powering From Euler??
#1
Hi all, it's a pleasure to be here on the forum. This is my first post, but I have been shaddowing on the site for quite some time. I finally received my Pine64 2G model and would like to power the device from the Euler port. I have various power adapters of varrying voltages and I have read reports of people using up to 5.2V over USB to power their device due to the voltage drop problem. However, I am not sure how this would apply to the Euler method. These are the power adapters I have:

- Offical Pine64 USB psu               @ 5.0V
- rpi3 Offical USB psu                     @ 5.1V
- GizmoJunkies rpi3 USB psu        @ 5.3v 


I don't want to burn the machine out so just wanted to check with you guys first to see which of the above would be best suited for this! I was leaning toward the rpi3 @ 5.1V but not too sure.

Thanks a bunch!
  Reply


Messages In This Thread
Correct Voltage For Powering From Euler?? - by thisrestricted - 10-10-2016, 08:02 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Lightbulb Alternate Power DC-IN on the Euler Bus also with PI filter for batt operation MarkHaysHarris777 13 25,232 12-19-2020, 09:53 PM
Last Post: evilpete
  First cable for Euler Bus power done! AVL2016 24 32,512 10-05-2016, 06:43 AM
Last Post: Ghost
  Can I Use 2 Pine Power Supplies on 1 Pine A64 Board Using the Euler Port? Bob123456789 2 4,936 05-10-2016, 05:48 PM
Last Post: Bob123456789

Forum Jump:


Users browsing this thread: 1 Guest(s)