Z-Wave module pinout to make it compatible with Pi b+
#14
Clearly, the lower module was designed for the later PI bus, not the PI(1); its a 40 pin layout.

...  the square pin is typically pin(1) so the alignment of the lower module would be with the module to the inside of the pine board...  I can see the Rx and Tx pins labels on the end of the lower module; so its accessing uart2 ( ttyS2 ) on the PI bus... what are the other pin names on that board ?  Also, clearly this board was not designed for use with any PI ( let alone the PI(1) ) and was designed for use on the Pine board. Supposedly they have been tested/  what is your question about this module ?



If you want to know can you plug it onto the PIb  ( PI(1) )  by aligning pin(1), then yes. The module probably won't work, but it won't break anything on the PI.  The PI's uart is on the same pins, but its called ttyS0, or serial0, ttyAMA0,  ...  as for the other pins ( depending on which ones are being used ) it may are may not work plugged into the PIb.  You might want to take a meter (with continuity checker, and the lower module only) and trace where each of the upper module pins goes one-by-one.



Another way to say this is, if you trace the lower module to any of the pins higher than pin 26, the board is not going to be at all compatible with the PIb (twenty-six pin layout).

But, just because you trace all of the pins to the lower 26 pins (1 - 26) does not mean it will work !
marcushh777    Cool

please join us for a chat @  irc.pine64.xyz:6667   or ssl  irc.pine64.xyz:6697

( I regret that I am not able to respond to personal messages;  let's meet on irc! )
  Reply


Messages In This Thread
RE: Z-Wave module pinout to make it compatible with Pi b+ - by MarkHaysHarris777 - 09-07-2016, 12:01 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
Sad Z-Wave and openzwave+node-openzwave-shared saro 2 6,218 09-01-2017, 05:22 AM
Last Post: saro
  Z-Wave - Full and Low Power Inclusion mode B34N 1 4,195 03-26-2017, 06:03 PM
Last Post: B34N
  What cameras are compatible with that ribbon connector? nayrenitnatsnoc 1 3,818 02-18-2017, 11:50 PM
Last Post: dkryder
  KICAD Quick Lib and Module Generator mbt28 1 4,612 02-12-2017, 10:45 PM
Last Post: tllim
  Z Wave Module and still using GPIO bang 2 5,702 01-16-2017, 03:12 AM
Last Post: bang
  Z-Wave US module with adapter aegrotatio 4 7,135 01-08-2017, 12:03 AM
Last Post: aegrotatio
  RaZberry Module (z-wave) need support to get it working! Luxus 13 18,711 11-03-2016, 02:04 AM
Last Post: Luxus
  Z-Wave module problem vintagewaffle 0 2,318 10-26-2016, 10:50 AM
Last Post: vintagewaffle
  Raspberry Pi and Arduino accessories compatible? Krowyn 6 10,506 10-08-2016, 10:36 AM
Last Post: rohan
Video Australia/New Zealand Z-Wave module Jnimmo 46 53,444 10-02-2016, 02:25 PM
Last Post: tllim

Forum Jump:


Users browsing this thread: 1 Guest(s)