Update on shipment status for ABS case, Playbox enclosure, and ZWave module

[MarkHaysHarris777]

I also just tried to set up my z wave module with the enclosure and the zwave module sits too high up to close the case...what are we supposed to do? Also an IoT kit backer....

The obvious solution to this embarrassing delema and technical DIY challenge is to replace the connector on the z-wave module with a ribbon cable which then runs over to the board. I would use velcro stickies to mount the z-wave mod away from hand-hold positions and leave plenty of ribbon length for easy installation. Right-angle header connectors can be used;  however, I would use the connector I removed from the z-wave module as the connector for the pine board headers; solder a ribbon cable to the connnector and run it over the the z-wave module , where it will be soldered in place as well.