09-13-2016, 02:09 PM
(09-13-2016, 11:36 AM)martinayotte Wrote: According to the picture from https://cdn.shopify.com/s/files/1/1013/5...1455062700
it is connected to the EULA ten last pins, therefore, it is using PB8/PB9 as UART0, so the same as the debug console connector, so, /dev/ttyS0
(I don't know if there will be conflict with the console, I don't own this ZWave board.)
The zwave module I received a couple of days ago is connected to the PI2 port (via an adapter) and thus uses the UART2 port. I suspect that the linux image I am using does not have the UART2 activated, but I have not had the time to investigate this further. The maintainer of Openhab mentioned in another thread that they will release an image in the near future with support for the zwave module so I will probably wait for it.
