Need a working image for Quartz64B
#9
(08-11-2022, 09:48 PM)Excalibur Wrote: Just got a model B and tried to do some verification. I have tried the following 2 images, but none of them is working correctly:

Manjaro-ARM-minimal-quartz64-b-20220808.img.xz: Serial output is entirely corrupted. It seems the system is booted into the OEM setup mode, and whenever I press the enter key it will immediately return some junk back. I assume it was asking for some question and won't take an empty response as answer, so it was asking again.

Armbian_22.08.0-trunk.0114_Quartz64a_jammy_edge_5.19.0.img.xz: No image for Model B from Armbian, so this A image has to do. The serial output is less corrupted with some recognizable words but far from a clean output. It is in a boot loop so not usable.

The serial cable and settings works correctly on a Radxa ROCK 4 so this has to be the board's issue right? (Right?) I tried to replace the DC power supply with another one with no avail since I think there might be some noise from the ground plane. They are 2 prong design though.

Latest manjaro XFCE image works (with several monitors 1080P).
  Reply


Messages In This Thread
Need a working image for Quartz64B - by Excalibur - 08-11-2022, 09:48 PM
RE: Need a working image for Quartz64B - by t4_4t - 08-12-2022, 04:21 PM
RE: Need a working image for Quartz64B - by t4_4t - 08-12-2022, 05:22 PM
RE: Need a working image for Quartz64B - by Johannes - 01-02-2023, 01:01 PM
RE: Need a working image for Quartz64B - by tllim - 01-23-2023, 09:02 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Quartz64B eMMC boot failure bsmorgan 2 780 11-15-2023, 12:00 AM
Last Post: balbes150
  can't get quartz64-A working jyoung 14 5,661 04-29-2023, 04:41 PM
Last Post: diederik
Tongue Trying to get Quartz model A working fasani 2 2,485 09-17-2022, 06:43 AM
Last Post: balbes150

Forum Jump:


Users browsing this thread: 1 Guest(s)