Need a working image for Quartz64B
#21
That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.
  Reply
#22
(02-22-2023, 04:42 AM)diederik Wrote: That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.

The reason is not u-boot. Before it, a binary blob starts controlling the primary memory configuration, u-boot and EDK2 use almost the same primary blob. There is no output since the start of the primary loader , which means the hardware is not working.
  Reply
#23
(01-24-2023, 11:51 PM)balbes150 Wrote:
(01-24-2023, 11:16 AM)diederik Wrote: I still need to look further into it, but I had the same issue with a Model-B, no output on both UART adapters (both woodpecker), while both work fine with Model-A.
The Model-B did work fine though (with Plebian), just no output on the serial console.

Yes, I have the same, there is no output to UART,

I think I've found the reason :-)
I have a Model B v1.4 and @CounterPillow appears to have a v1.3 and his serial is working.

Do you happen to have a v1.4 too?
  Reply
#24
Ver 1.4 2022.06.06
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Quartz64B eMMC boot failure bsmorgan 2 438 11-15-2023, 12:00 AM
Last Post: balbes150
  can't get quartz64-A working jyoung 14 4,136 04-29-2023, 04:41 PM
Last Post: diederik
Tongue Trying to get Quartz model A working fasani 2 2,131 09-17-2022, 06:43 AM
Last Post: balbes150

Forum Jump:


Users browsing this thread: 1 Guest(s)