07-13-2016, 02:01 PM
(07-13-2016, 11:24 AM)xalius Wrote: After a quick look, the only thing I could see was that the pins on my board and other boards (see pic on the left from the linux-sunxi wiki on the Pine) are protruding a lot more through the holes, maybe a pin of the connector was bent while placing the part? Or is it just the angle at which the picture was taken that makes your pins look shorter?
http://i.imgur.com/yspDtty.jpg
You are absolutely correct, missed that one big time..definitely looks like one pin is bent under, rather than thru the board (typing as I toss the new reading glasses out the window......).