"Pine64 USB JTAG Adapter + OpenOCD + PineTime" should it work?
#5
I'm going on a little reading and informed guesswork, so treat what I'm about to say accordingly.

I would investigate the 5V issue first - if the adapter sends 5V to a device that can't tolerate it you will cause permanent damage. That's how people end up with dead GPIO pins on their Pi, or even a dead Pi. The adapter schematic doesn't show a 3.3V regulator, and I don't know if the FT232H has an internal one and a level config option. If it doesn't then you'll need to look for a bidirectional level converter to move the signals between 5V and 3.3V.

https://www.allaboutcircuits.com/technic...debugging/
https://plaes.org/technotes/embedded-sys...e-hacking/

Based on the above it looks like you need both TDI and TDO (via a resistor) connected to SWDIO. The first one has some detail on what each bit of the config actually means too.
  Reply


Messages In This Thread
RE: "Pine64 USB JTAG Adapter + OpenOCD + PineTime" should it work? - by wibble - 03-02-2022, 05:58 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Develop a new firmware for PineTime belushi 2 1,282 09-25-2023, 12:32 PM
Last Post: ccchan234
  Bluetooth BLE-MIDI-controller app for PineTime / InfiniTime Luno 0 501 08-20-2023, 05:17 AM
Last Post: Luno
  Zephyr Backlight Examples for PineTime lcj 0 691 05-06-2023, 02:54 PM
Last Post: lcj
  Zephyr is ready for pinetime jandy 1 2,075 05-06-2023, 02:15 PM
Last Post: lcj
  Send a message from Android to pinetime via BLE razrosman 0 905 11-05-2022, 08:24 AM
Last Post: razrosman
  PineTime Stuck in DFU Mode Eesha Barua 1 2,001 07-25-2022, 09:17 PM
Last Post: heyhewmike
  Idle tracking with PineTime: how versatile it is? schaman 1 1,614 07-13-2022, 12:50 AM
Last Post: wibble
  PineTime implemented with partial of pebble API jandy 0 1,535 03-20-2022, 08:58 PM
Last Post: jandy
  Zephyr based Pinetime jandy 4 4,634 11-11-2021, 05:53 AM
Last Post: jandy
  Problems with pinetime watch face simulator Elements 0 1,903 08-18-2021, 03:05 PM
Last Post: Elements

Forum Jump:


Users browsing this thread: 1 Guest(s)