05-10-2023, 06:13 PM
(05-09-2023, 07:08 AM)Josef Söntgen Wrote: We did change the clock of the MMC controller and that could explain the issues you encounter with your SD card. I prepared a test image (SHA256 df08bf3f15a0c05d09067d512a4c6619b183bd0eaa745c86897bdd7891b9d99a) and I would appreciate it if you would give that a try. It lowers the clock back to the setting that was used in the previous version.
Thanks for the test image. As a detail, I'm running the 3GB version since some of the doc's for this new Sculpt OS mention likely issues for the browser, etc. for the 2GB version.
Got everything to install and test out with your new test image.
Here are still some lingering issues:
1) I originally noticed the # sign doesn't work for the phone, but actually the issue appears to be it doesn't register text input commands. An example is checking voicemail which requires typing in the phone number and hitting a button below the touch pad to initiate the call. It then asks for your PIN and to press #. Normally when you start typing, the audio message to type in your PIN number stops. However, it keeps going implying it's not registering the typing. Curious if this also occurs for the browser if anyone can think of a site that triggers something when text is typed into an input, but no button is hit afterward.
2) When hitting reboot, I saw a brief flash of the Sculpt OS and then the red light went off again implying an error reading the SD card and the default Manjaro OS began to boot up. When accessing the SD card in the laptop afterwards again reads "16 GB Volume" instead of the previous "Genode."
3) I had the convergence pack hooked up to deliver both ethernet and a power chord at the same time to make sure I had enough power for installing and testing out the Presets. Briefly, DEVICE showed "AC," but most of the time it showed the power slowly ticking down implying that it's not receiving power. Note: this is the power chord I use on a regular basis and works fine with other PinePhone OS's.
That's what I've noticed so far and am happy to test out newer images before your next big release. Also, I started a poll to get Genode/Sculpt OS it's own PinePhone Software subforum so all related content can be found in one spot: https://forum.pine64.org/showthread.php?tid=18211
