Firmware BL602 on magic home controller
Dear forum,

I recently stumbled over the PineCone/Nutcracker challenge when I was trying to flash a custom firmware on my "Magic Home" Wifi LED controller. Those controllers  had an ESP based chip in the past but recently switched to BL602. Curious I read about recent developments and decided to play around with the chip as well. I used blflash to dump the existing firmware but apparently I did not recognize that by default blflash only dumps 1 MB, whereas that particular controller seemed to have 2 MB.

Does anyone here have such a Magic Home controller and is able to provide me a dump of the original firmware please? Thank you in advance

Possibly Related Threads…
Thread Author Replies Views Last Post
  Article: BL602 Bootloader lupyuen 2 405 09-09-2021, 11:35 AM
Last Post: lupyuen
  Article: Rust on RISC-V BL602: Rhai Scripting lupyuen 0 83 09-04-2021, 12:08 AM
Last Post: lupyuen
  Article: Rust on RISC-V BL602: Simulated with WebAssembly lupyuen 0 140 08-15-2021, 07:13 PM
Last Post: lupyuen
  Article: Rust on RISC-V BL602: Is It Sunny? lupyuen 0 235 08-02-2021, 06:17 PM
Last Post: lupyuen
  Article: Reverse Engineering WiFi on RISC-V BL602 lupyuen 4 1,028 07-08-2021, 09:20 PM
Last Post: lupyuen
  Article: Machine Learning on RISC-V BL602 with TensorFlow Lite lupyuen 0 350 06-21-2021, 06:52 AM
Last Post: lupyuen
  Pine power firmware DuncanT 2 744 05-27-2021, 02:36 PM
Last Post: DuncanT
  Article: Simulate PineCone BL602 with WebAssembly, uLisp and Blockly lupyuen 0 373 05-27-2021, 07:37 AM
Last Post: lupyuen
  Article: uLisp and Blockly on PineCone BL602 RISC-V Board lupyuen 3 891 05-21-2021, 11:58 PM
Last Post: nimblemotors
  Article: PineCone BL602 Talks LoRaWAN lupyuen 0 419 05-11-2021, 12:12 AM
Last Post: lupyuen

Forum Jump:

Users browsing this thread: 1 Guest(s)