Pinedio Project: Notes Sharing/Log

[RTP]

*Testing* image of Armbian w/RAKWireless Chirpstack/TTN can be found here:
https://mega.nz/file/nI42BCAD#oUWRJYg0UC...3uBRw0prjc

On Boot:

* Armbian 5.10.34 (latest as of this posting)
* Devices/hardware setup
* Starts GPS (be sure to have reliable/proper antenna outside or at a window)
* Starts up the Concentrator
* Starts up ready to login Chirpstack (web interface: http://IPaddress:8080)

SSH access:

login: pine
password: SoPinePass!

CHIRPSTACK GATEWAY/NETWORK MANAGEMENT (web interface):

http://IPaddressOnLAN:8080

login: admin
password admin


*Make sure to change default passwords*


Useful Commands:

gateway-config (configures gateway options including:
- channel (specific to your area)
- concentrator/GPS specific: packet forwarder config (defaults set for pine64 Pinedio),
- switch between Chirpstack local and TTN

journalctl | grep -i eui (grab gateway eui)

systemctl status ttn-gateway (check your gateway service status)

systemctl stop ttn-gateway

systemctl disable ttn-gateway (disable



Software:

Armbian OS: https://www.armbian.com/download

Gateway Software Fork installed for Pinedio Gateway: https://github.com/RightToPrivacy/rak_co...or_gateway (fork edit of https://github.com/RAKWireless/rak_common_for_gateway [for raspberry pi's])

Thanks, are you developed on the new Pine A64-LTSv2 board with the Motocomm 8511 GbE phy?

Hey there TL,

Haven't had the chance just yet as have had a few things occupying.

(I did receive a short email from the copied address, wasn't very clear how far, put aside temp until I could look try another one).

Planning to have another look at it when I get back from a trip (heading out in a few hours).

Will probably start out with an older version when I get back and see how things go.