11-30-2020, 11:25 AM
(11-30-2020, 06:12 AM)3xC0MM Wrote: Hi,
I am using the PBP with Manjaro KDE Plasma 20.10 (the last update).
I was following the steps from this forum page in order to be able to use the suspend to ram feature: https://forum.pine64.org/showthread.php?tid=10250
All the steps went fine, but after reboot the green light appears immediately and nothing else happens.
Can you please help?
1. Was I doing anything wrong? I have a 128GB emmc installed.
2. How can I recover from this state?
(11-30-2020, 06:12 AM)3xC0MM Wrote: Hi,
I am using the PBP with Manjaro KDE Plasma 20.10 (the last update).
I was following the steps from this forum page in order to be able to use the suspend to ram feature: https://forum.pine64.org/showthread.php?tid=10250
All the steps went fine, but after reboot the green light appears immediately and nothing else happens.
Can you please help?
1. Was I doing anything wrong? I have a 128GB emmc installed.
2. How can I recover from this state?
And now I just did it again for my 64GB emmc
Installed uboot-pinebookpro-bsp (1.5-7), and ran
sudo dd if=/boot/idbloader.img of=/dev/mmcblk2 seek=64 conv=notrunc
sudo dd if=/boot/uboot.img of=/dev/mmcblk2 seek=16384 conv=notrunc
sudo dd if=/boot/trust.img of=/dev/mmcblk2 seek=24576 conv=notrunc
My 2 emmcs are not booting anymore.
I suppose that I can take them out, re-imagine them using my Mac and the SD-EMMC adapter + the Manjaro 20.10 image.
But I would like to recover them though, without reinstalling everything.
Can anyone help with a procedure on how to make them again to boot?
Thank you very much in advance.
Update nr. 2
1. I have created a bootable SD with Manjaro 20.10
2. I have opened the back cover and disabled the emmc switch
3. I have inserted the SD and started the PBP, and after 5 seconds I have turned on the emmc switch
4. I ended up to my login page. I logged in and I have realised that the laptop is using now the /boot partition of the SD and the /root of the emmc
5. The wifi card is not detected
I will try to check how can I reflash the uboot from this state, to be able to boot again from the emmc. Until now I have no clue how to do it.