09-05-2020, 10:57 PM
(This post was last modified: 09-05-2020, 11:07 PM by Peter Gamma.)
Questions how to build a connection between Rasperri PI, Pinephone, MQTT, Matlab. All information are there. But for someone who is not familiar with Bluetooth low energy sensor streaming and MQTT this is a hard job. For others it's an easy one. An example would be very helpful, for instance for the Rasperri PI, which then can be developed further, run on the Linux Pinephone, etc.
https://ch.mathworks.com/matlabcentral/a...contriblnk
https://ch.mathworks.com/matlabcentral/a...contriblnk
https://ch.mathworks.com/matlabcentral/a...contriblnk
There is an Android app IpBike which supports ANT+ sensors and BLE sensors. Unfortunately, IpBike does not offer Ip streaming. Is this not a shame?
https://ch.mathworks.com/matlabcentral/a...contriblnk
I wrote a long thread in the support forum of IpBike about this subject. Unfortunately, the developer Ifor Powell did not react to my posts. It is difficult do depend on an Android app which is not open source for an Ip stream, and to depend on a developer which does not seem to be interested in new developements. Therefore I m promoting development of an Ip stream on the Pinephone.
https://ch.mathworks.com/matlabcentral/a...contriblnk
https://ch.mathworks.com/matlabcentral/a...contriblnk
https://ch.mathworks.com/matlabcentral/a...contriblnk
There is an Android app IpBike which supports ANT+ sensors and BLE sensors. Unfortunately, IpBike does not offer Ip streaming. Is this not a shame?
https://ch.mathworks.com/matlabcentral/a...contriblnk
I wrote a long thread in the support forum of IpBike about this subject. Unfortunately, the developer Ifor Powell did not react to my posts. It is difficult do depend on an Android app which is not open source for an Ip stream, and to depend on a developer which does not seem to be interested in new developements. Therefore I m promoting development of an Ip stream on the Pinephone.
