USB Type-C connector overmold conflicts with the back cover
#1
Bug 
I found that the plug overmold conflicts with the back cover when using the cable with a short plug (6.6mm). It charges the phone, but the retention mechanism is loose and the cable falls out when it swings.

According to Universal Serial Bus Type-C Cable and Connector Specification Release 2.0 page 46, the minimum length of the type-c plug is 6.51mm, so PinePhone should accept this cable.

FYI the Type-C specification recommends >=0.05mm clearance between the exterior surface of the product and plug overmold.


Messages In This Thread
USB Type-C connector overmold conflicts with the back cover - by ngkz - 05-09-2020, 06:26 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  GPS Antenna - external connector? GregH 14 7,894 09-09-2021, 09:24 AM
Last Post: HobanWashburn
  Fragile SIM card connector hakkou 1 1,273 08-25-2021, 07:44 AM
Last Post: wibble
  USB C connector loose? bceverly 3 1,940 08-10-2021, 09:44 AM
Last Post: c3l@
  Back cover plastic woes mteagles1942 6 4,577 03-28-2021, 10:19 PM
Last Post: NormandC
  Back cover with UBPorts logo cracked Phillip Bell 7 5,225 03-22-2021, 12:20 PM
Last Post: mteagles1942
  Micro-USB 3.0 connector for the PinePhone? Peter Gamma 1 1,555 03-10-2021, 10:11 AM
Last Post: wibble
  broken connector-pin for the accu alwi 2 1,973 02-23-2021, 06:28 AM
Last Post: scholbert
Question Approximate leadtime for when the 3GB/32GB mainboard is back in stock? NormandC 2 2,329 12-15-2020, 10:29 PM
Last Post: NormandC
  Main Board Swap: Camera connector problems tyha 5 3,230 11-19-2020, 06:25 PM
Last Post: pajux
  Could information be printed on the inside back cover? desca 0 1,045 10-21-2020, 02:15 PM
Last Post: desca

Forum Jump:


Users browsing this thread: 1 Guest(s)