replacing back-screw standoffs

[sundog]

It's been 30 years since drafting class and if you have any problems reading it let me know.

https://www.dropbox.com/s/blmvy6or9r0hhe...1.jpg?dl=0
https://www.dropbox.com/s/80ld7mvhy32qzw...2.jpg?dl=0
https://www.dropbox.com/s/9n7sdm1ah3r727...1.jpg?dl=0
https://www.dropbox.com/s/6i7genzs6r5246...4.jpg?dl=0
https://www.dropbox.com/s/hscizbic0svesy...0.jpg?dl=0
https://www.dropbox.com/s/q009s69wjfk0vy...8.jpg?dl=0

I know, it's terrible but it should give you a good idea.

---

Ohhhh, if you tape it down, I don't think you'd need the little alignment tabs. Super Glue might work too.

This is awesome - thanks so much for doing this!!

I'll see about putting this through openscad later this afternoon to get some initial prints done - I'll let you know how it goes.

Thanks again, you're the best!