PINE64   ›   ROCK64   ›   Rock64 Hardware and Accessories   ›   USB3 to SATA cable - Firmware

USB3 to SATA cable - Firmware
Eule
Pine Initiate
**
Joined: Mar 2020
Posts: 1

Reputation: 0
#1
03-03-2020, 01:31 PM
Hello everybody,

I have a USB3 to SATA cable with JMS578 and firmware version v0.4.0.9.
Unfortunately I am not able to use hdparm to detect drive state (= unknown). I also would like to control spindown.

I found several threads which recommends to update to firmware version v173.1.0.1 from here: odroid wiki

What do you think about it?

Best regards
Oliver
  Reply


Messages In This Thread
USB3 to SATA cable - Firmware - by Eule - 03-03-2020, 01:31 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Information How to Setup Serial Console Cable Over the Rock64 SBC MarkHaysHarris777 9 33,428 09-28-2021, 10:52 AM
Last Post: lewiscamron72
  USB3 SATA ReleaseTheGeese 2 2,765 04-04-2021, 12:55 PM
Last Post: ReleaseTheGeese
  USB3 enough to power 2,5 external HDD? va88 11 14,214 06-06-2019, 03:40 PM
Last Post: va88
  PCIe extender cable for M2 grimace 1 2,493 02-15-2019, 11:15 AM
Last Post: fonix232
  Does the Pine usb to sata adapter work with hd-parm? FabrizioMaurizio 0 1,757 02-06-2019, 11:37 AM
Last Post: FabrizioMaurizio
  GPIO extension cable fault viguzzz 12 13,401 05-18-2018, 04:03 AM
Last Post: viguzzz
  unable to switch usb3 ports on cglhu 6 8,020 05-17-2018, 08:43 AM
Last Post: cglhu
Bug Rock64 Boot-up Bug with Serial Console Cable MarkHaysHarris777 1 6,759 04-13-2018, 03:45 AM
Last Post: Z80
  USB 3 2.5" SATA Case thewonderer 2 3,764 12-13-2017, 06:05 PM
Last Post: thewonderer
  Best USB3.0 to SATA bridge mikedhoore 6 15,039 10-02-2017, 07:52 AM
Last Post: mikedhoore

Forum Jump:


Users browsing this thread: 1 Guest(s)