01-10-2020, 04:35 PM
Just got my PineBook Pro and ran the ANSI firmware update. Things are working pretty well but the trackpad has a peculiar behavior. It's like the mouse position is a couple steps behind the buffer for the trackpad. For instance, if I move left, then stop, then move up. When i start moving up, it goes left a little bit then up. It's just a bit behind and it doesn't update until new input to the trackpad is made.
If it's not just me, maybe I can help sort it out and post a patch? Very new to Pine and the hardware. If that is the case, would you have recommendations on where to start looking into the code? Very comfortable with hardware and mircocontrollers.
Really excited about this project, thanks everyone for their help and contributions!
If it's not just me, maybe I can help sort it out and post a patch? Very new to Pine and the hardware. If that is the case, would you have recommendations on where to start looking into the code? Very comfortable with hardware and mircocontrollers.
Really excited about this project, thanks everyone for their help and contributions!
