PineA64 Getting Started Guide
#7
(07-06-2016, 07:13 AM)grantos Wrote: Cable is attached to module but not sure where to glue/stick other end that had 3M tape?

As far from the board as possible (which isn't that far, because the cabling isn't too long). 

Mine is stuck to the acrylic case and works ok.


Messages In This Thread
PineA64 Getting Started Guide - by khgoh - 04-28-2016, 03:50 AM
PineA64 Getting Started Guide - by grantos - 07-02-2016, 07:52 PM
RE: PineA64 Getting Started Guide - by sqr00t - 07-05-2016, 02:58 AM
RE: PineA64 Getting Started Guide - by Doryan - 03-04-2017, 08:53 PM
PineA64 Getting Started Guide - by grantos - 07-05-2016, 07:46 AM
RE: PineA64 Getting Started Guide - by Ghost - 07-05-2016, 11:51 AM
PineA64 Getting Started Guide - by grantos - 07-06-2016, 07:13 AM
RE: PineA64 Getting Started Guide - by Ghost - 07-06-2016, 11:49 AM
RE: PineA64 Getting Started Guide - by grantos - 07-06-2016, 08:24 PM
RE: PineA64 Getting Started Guide - by Ghost - 07-06-2016, 11:53 PM
PineA64 Getting Started Guide - by grantos - 07-07-2016, 01:48 AM
RE: PineA64 Getting Started Guide - by Ghost - 07-07-2016, 06:39 AM
RE: PineA64 Getting Started Guide - by Luke - 07-07-2016, 10:48 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Guide: Setup Latest Waydroid for Hardware Acceleration and/or Development nroth 2 4,194 11-11-2022, 04:47 PM
Last Post: nroth
  Getting started in nRF52 in pinetime64 Quim 0 2,123 06-14-2020, 02:02 PM
Last Post: Quim
  Any success working with OpenCV on the PineA64? Tonny91 0 2,415 10-16-2018, 09:16 PM
Last Post: Tonny91
  How to get started? riahim 35 67,848 10-19-2017, 02:04 PM
Last Post: hikmetsezen
  PineA64 512 reboot - board shut down indrajith 7 12,479 07-28-2016, 02:07 PM
Last Post: Ghost
  Startup Guide (READ THIS FIRST) ScorpionTNT 3 6,317 07-18-2016, 10:33 AM
Last Post: Luke
  Getting started using OSX cranchh 17 31,699 06-23-2016, 11:40 AM
Last Post: killorfb
  Youtube video on PineA64 Development Board khgoh 0 3,973 03-30-2016, 11:25 PM
Last Post: khgoh

Forum Jump:


Users browsing this thread: 2 Guest(s)