Serial console
#4
(10-17-2019, 02:43 AM)jsuchecki Wrote:
(10-16-2019, 07:13 AM)martinayotte Wrote:
(10-16-2019, 04:27 AM)jsuchecki Wrote: The listening during SBC launch is set to 1.5 Mbps (same as in Rock64 case)
No ! H64 initial baudrate is 115200 ...

Thanks, valuable note but if I remember it also was tested on 115200. By the way it doesn't describe oscilloscope measurement.


I have the same problem - but I had assumed that the H64 was using UART0 on the 6 pin EXT pin block (2,4,6).  If indeed we should be using UART1 like on the rock64's, I haven't been able to get those to work either:

http://files.pine64.org/doc/Pine%20H64/P...rev2.0.pdf


Messages In This Thread
Serial console - by jsuchecki - 10-16-2019, 04:27 AM
RE: Serial console - by martinayotte - 10-16-2019, 07:13 AM
RE: Serial console - by jsuchecki - 10-17-2019, 02:43 AM
RE: Serial console - by SuburbanDad - 11-14-2019, 02:12 PM
RE: Serial console - by xalius - 11-14-2019, 02:29 PM
RE: Serial console - by SuburbanDad - 11-14-2019, 03:24 PM
RE: Serial console - by SuburbanDad - 11-14-2019, 09:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)