Clusterboard networking problems

[AZClusterboard]

They aren't asking for addresses from the router, so I wonder if there's something wrong with my clusterboard.

They won't pull down DHCP at all?

They weren't, but they are now. I assumed the most obvious answer here, that of I did something wrong. I went back and re-read your guide carefully, and stopped where you said you HAD to use Xenial. I loaded that on to a test card, and it appeared in the router as a device within a minute.

So, I guess I need to pay attention to the manual. The board currently has 3 modules on it, just doing some generic network tasks for a burn-in. The only thing I have left to do is make sure there's no unnecessary desktops loading with this particular version. I assume there isn't.

Thank you for the replies, sometimes it just takes someone asking you about it to make you go back and look at your process differently.

I'm still waiting on my USB UART and LTS baseboard.  I had to way to troubleshoot the problem which is why I used xenial.  I have a feeling the newest images might not have all the proper configs to run headless out of the box.