09-06-2018, 07:06 AM
(This post was last modified: 09-06-2018, 08:07 AM by jovval.
Edit Reason: see EDIT:
)
(09-04-2018, 02:30 PM)Rocklobster Wrote: Now that you have your board booting post a picture as suggested by tllim above.
EDIT: Also, when the serial cables are attached to the PI-2 bus and I connect the power, the dim blue led next to the bus goes dark while the red led stays lit. The power led goes from dim green to bright green. minicom disconnects and /dev/ttyUSB0 disappears replaced by /dev/ttyUSB1 (which gives me the same non-results when I try to connect to through it via minicom).
I have no evidence that the board is booting. The ethernet jack shows no lights and my dhcpd shows no request for an IP.
As I stated,
"With or without the serial cable attached, my Rock64 does not appear to boot.
I do have an ethernet cable plugged into the Rock64. Shouldn't the adapter's light(s) come on if the Rock64 successfully boots? "
I can not post a picture, as I do not have a camera. Otherwise, I would have gladly complied with your first request. I did not mean to seem rude.
If I can track down a camera with suitable software, I will post a shot of what I have. I appreciate your interest and your willingness to help.