05-28-2018, 05:48 AM
Hello all,
I'm thinking of buying the 99$ Texas Instruments DLP projector for the BeagleBone.
It can be wired up to a raspberry pi as well.
http://www.ti.com/tool/DLPDLCR2000EVM
I very much want to know if this can be configured on an Ayufan Ubuntu Bionic image.
These are the instructions to make it work with a Raspberry Pi:
https://www.mickmake.com/post/build-a-pi...-project/2
(Also a video tutorial from the same guy):
I guess I should start off by asking what are the main differences when using the GPIO on a Rock64 vs a Raspberry.
Also, where do I find the R64 equivalent of /boot/config.txt and /etc/rc.local from the raspbian OS?
The tutorial says one must modify both of these files on a raspberry. That, and enable I2C.
I'm a noob with SBCs, so all help is welcome.
Thank you for your time.
I'm thinking of buying the 99$ Texas Instruments DLP projector for the BeagleBone.
It can be wired up to a raspberry pi as well.
http://www.ti.com/tool/DLPDLCR2000EVM
I very much want to know if this can be configured on an Ayufan Ubuntu Bionic image.
These are the instructions to make it work with a Raspberry Pi:
https://www.mickmake.com/post/build-a-pi...-project/2
(Also a video tutorial from the same guy):
I guess I should start off by asking what are the main differences when using the GPIO on a Rock64 vs a Raspberry.
Also, where do I find the R64 equivalent of /boot/config.txt and /etc/rc.local from the raspbian OS?
The tutorial says one must modify both of these files on a raspberry. That, and enable I2C.
I'm a noob with SBCs, so all help is welcome.
Thank you for your time.