but do not use the -5V as GND, use the GND from your power supply. otherwise you will get a difference of 10V which will most likely kill the Rock64. After reading this i finally understand your problem from the other thread. maybe you should look deeper into electronics before you solder anything. Damage done by wrong voltage is irreversible most of the times.
Secondary power input for Rock64 through pi2 Bus
|
Messages In This Thread |
Secondary power input for Rock64 through pi2 Bus - by nmhart322 - 12-16-2017, 04:45 PM
RE: Secondary power input for Rock64 through pi2 Bus - by xalius - 12-16-2017, 05:07 PM
RE: Secondary power input for Rock64 through pi2 Bus - by mikedhoore - 12-17-2017, 02:42 AM
RE: Secondary power input for Rock64 through pi2 Bus - by dkryder - 12-17-2017, 06:44 AM
RE: Secondary power input for Rock64 through pi2 Bus - by nmhart322 - 12-17-2017, 04:58 PM
RE: Secondary power input for Rock64 through pi2 Bus - by xalius - 12-17-2017, 08:41 AM
RE: Secondary power input for Rock64 through pi2 Bus - by Lamensis - 12-18-2017, 01:56 AM
|
Users browsing this thread: 1 Guest(s)